RZR 7075 XP 1000 Rear Knuckle Set

The radius rod through bolts are 12MM ONLY

Made from 7075 Aluminum these bearing carriers address the bearing push-out issue seen by racers and recreationalists alike. We eliminated stress risers and added cross section in all the right spots to make this part truly race proven.

Push-out on the ZRP knuckle is over 2.5X the factory knuckle. This is achieved through superior USA Made material as well though the use of a ear-less snap ring, maximizing surface area. The stock cast knuckle took 22,000 PSI to press the bearing out, our 100% billet made in the U.S.A. knuckle took 63,000 PSI to press the bearing out.

Made from high quality, USA made, 7075-T6 Aluminum in our in-house state of the art machine shop.

Proposition 65